Earlier today, the Federal Bureau of Investigation awarded a contract to Glock for new 9mm duty pistols. The new contract has a potential value of $85 million over 10 years.
The FBI amplified a conversation regarding the relative effectiveness of different handgun cartridges when its training division published a paper in 2014 justifying the use of the 9mm cartridge for law enforcement use. A year later, the agency published a request for proposal (RFP) for new 9mm duty pistols.
FBI Drops the .40 S&W
Currently, the FBI issues Glock handguns in .40 S&W – a cartridge that was developed largely because of the FBI’s condemnation of the 9mm in the wake of the infamous Miami shootout. The FBI transitioned to the 10mm, but had problems with full power loads.
[Ultimately, the FBI selected the gun that became the Glock 17 Gen5.]
Subsequently, the .40 S&W was introduced: a 10mm bullet at lower velocities. Many departments saw the .40 S&W as the ideal compromise of power and capacity. During the 1990s many departments moved from both the 9mm and .45 ACP to the .40 S&W.
What Are the New Guns?
At the time of this writing, neither Glock nor the FBI have released specific details on the guns chosen. However, we know what the FBI was looking for in the new pistols:
- a compact 9mm pistol with a barrel length of 3.75 – 4.25″ and a minimum magazine capacity of 14 rounds
- a full size 9mm pistol with a barrel length of 4.26 – 5.20″ and a minimum magazine capacity of 16 rounds
Under normal circumstances, that would be a Glock 19 and Glock 17 respectively. However – and this is a big one for the current and previous generation of Glock pistols – the FBI stated:
Finger grooves on the frame are not permitted. (emphasis theirs)
The first and second generation of Glock pistols did not have finger grooves. Those were added in the third generation guns and were carried over to the Gen4 pistols. I’ve carried second, third and fourth generation Glock pistols, and I dislike the finger grooves.
For me, the ideal Glock grip matches the Gen4 texture with the second generation’s lack of grooves. Perhaps the FBI feels the same way.
It will be interesting to see if Glock releases grooveless frames to the general market. I would happily pick one up if they did.
The RFP
Additional Contract Information
In addition to the two pistols, the RFP had requirements for training and Simunition pistols along with parts for everything.
While the deletion of finger grooves mentioned above is one of the most obvious changes to the Gen4 guns that the FBI wanted, there were several other items in the RFP that are worth mentioning:
- magazine floor plates with a front ledge or tow to assist in stripping them from the magazine well
- a slight (no more than 0.10″) flaring of the magazine well
- use of Trijicon HD sights was listed as preferred
- the slide stop must be “easily manipulated by both left and right handed shooters” – this is subjective, but the FBI further indicated that ambidextrous slide stop levers were permitted and both standard and extended slide stop levers must be provided
Additional Agencies
In addition to the FBI, other federal agencies may purchase these pistols under the same contract. These agencies include, but are not limited to:
- Department of State
- US Marshals Service
- BATFE
- DEA
- DOD
- US Capitol Police
- US Park Police
Update
I’ve reached out to both the FBI and Glock for additional information. Neither have replied back. When I get more, I will update this article.
Last Update: October 23, 2022
11 replies on “BREAKING: Glock Awarded New FBI Contract”
Following
This FBI requirements may result in the creation Glock Gen 5 or 6
You are correct – a fifth gen Glock could be possible. Additionally, it could be a variation of the Gen4 like the RTF2 was to the third gen.
-Richard
I don’t think so. I could be wrong, but the Gen 3 was around for 12 years before the Gen 4 came along, and the former is still going strong after 18 years and preferred by many (including Naval Special Warfare). What I predict we’ll see is something along the lines of the special RTF textured Glock we saw come out a few times for the Gen 3. They may even do it for the Gen 4, but likely the Gen 3. It obviously will do away with the finger grooves more like a Gen 1 or 2, but I really don’t see another Gen, just an FBI version.
Yawn. Another glunk.
Are they doing this to have an excuse to buy up all the 9mm ammo and starve us civilians of the most popular caliber out there? Just thinking out loud.
Was the tin foil on sale?
“Just because you’re paranoid doesn’t mean they aren’t after you.â€
—Joseph Heller, ‘Catch 22’
Now that you mention it, it does kind of make me want to buy a Glock 23 with a conversion barrel to back up my Glock 19.
Complete waste of tax payer money. The Glock 22 and 23s they have on hand and the BILLIONS of rounds of .40sw they bought would last for years to come. Like another commenter said, it is an excuse for the government to now suck up all available 9mm ammo and manufacturing capacity. Oh, and about 15 years from now, we will be discussing how the 9mm is still to weak to stop a drug crazed lunatic.
9mm ammo is about to skyrocket.